In an orthogonal machining experiment carried out using a cutting tool with zero degree rake angle, the measured cutting force was $$1700$$ $$N.$$ If the friction angle at the rake face-chip interface is $${26^ \circ },$$ then the thrust force value, in $$N$$ is ___________________

Which one of the following statements related to grinding process is INCORRECT?

In a slab milling operation, a cutter of $$75$$ $$mm$$ diameter with sufficient width is used to remove $$5$$ $$mm$$ thick material from a $$200$$ $$mm$$ long part in a single pass. The minimum length of travel, in $$mm,$$ for the cutter to engage and completely cut the part surface is ______________.

In Computer Aided Process Planning, determination of process sequence for manufacture of any part design without predefined standard plans is known as