The length of a baseline measured on ground at an elevation of 300m above mean sea level is 2250 m. The required correct

The quadrantal bearings of the lines AB and CA are S $$30^o$$ E and S $$75^o$$ E, respectively the inclined angle CAB is

A saturated sand sample has dry unit weight of 18 $$kN/m^3$$ and a specific gravity of 2.65. If $$\gamma_w$$ = 10 $$kN/m

For sand of uniform spherical particles, the void ratio in the loosest and the densest states are ________ and ________

When the product of rock weathering is not transported as sediment but remains in place, is called

A tropical cyclone in a northern hemisphere is a wind stream with

A prestressed concrete beam has a cross-section with the following properties: Area $$A = 46,000\,\,m{m^2},$$ $${\rm I}

Setting time of cement sample is tested by

The moments at the end $$'A'$$ and $$'B'$$ of a beam $$'AB'$$ where end $$(a)$$ is fixed and $$(b)$$ is hinged, when the

A thin cylindrical vessel of mean diameter $$D$$ and of length $$'L'$$ closed at both the ends is subjected to a water p

For a given shear force across a symmetrical $$'{\rm I}'$$ section the intensity of shear stress is maximum at the

A beams having a double cantilever attached at mid span is showing in the figure. The nature of forces in beam $$'ab'$$

A cantilever beam of tubular section consists of 2 materials copper as outer cylinder and steel as inner cylinder. It is

In a linear elastic structural element

The maximum value of Poisson's ratio for an elastic material is

In a linear elastic structural element

Number of independent displacement modes (sway mechanisms) for the given frame with the load shown there in are

If the design speed is 80kmph, perception reaction time is 3sec and coefficient of friction is 0.5, then the SSD is ____