Consider the following steps in forging a connecting rod from the bar stock

$$1.$$ blocking $$\,\,\,\,\,\,\,\,\,$$ $$\,\,\,\,\,\,\,\,\,$$ $$\,\,\,\,\,\,\,\,\,$$$$2.$$ trimming
$$3.$$ finishing$$\,\,\,\,\,\,\,\,\,$$ $$\,\,\,\,\,\,\,\,\,$$ $$\,\,\,\,\,\,\,\,\,$$ $$4.$$ edging

Select the correct sequence of these operations using the codes given below

An annealed copper wire of $$25 mm$$ diameter is drawn into a wire of $$5$$ $$mm$$ dia. The average yield stress in this operation if the flow curve of the material is given
$$\sigma = 315{ \in ^{0.54}}\,MPa$$

If the elongation factor during rolling of an ingot is $$1.22.$$ The minimum number of passes needed to produce a section $$250 \times 250\,\,mm$$ from an ingot of $$750 \times 750\,\,mm$$ are