A Sine bar has a length of $$250mm.$$ Each roller has a diameter of $$20mm.$$ During taper angle measurement of a component, the height from the surface plate to the center of a roller is $$100mm.$$ The calculated taper angle (in degrees) is

Observation of a slip gauge on a flatness interferometer produced fringe counts numbering $$10$$ and $$14$$ for two readings. The second reading is taken by rotating the setup by $${180^ \circ }$$ Assume that both faces of the slip gauge are flat and the wavelength of the radiation is $$0.5086$$ $$\mu m.$$ The parallelism error (in $$\mu m.$$) between the two faces of the slip gauge is

To measure the effective diameter of an external metric thread (included angle is $$60$$ degrees) of $$3.5$$ $$mm$$ pitch, a cylindrical standard of $$30.5$$ $$mm$$ diameter and two wires of $$2$$ $$mm$$ diameter each are used. The micrometer reading over the standard and over the wires are $$16.532$$ $$mm$$ and $$15.398$$ $$mm$$ respectively. The effective diameter (in $$mm$$) of the thread is

A small bore is designated as $$25H7.$$ The lower (minimum) and upper (maximum) limits of the bore are $$25.000mm$$ and $$25.021$$ respectively. When the bore is designated as $$25H8,$$ then the upper limit is $$25.033mm.$$ When the bore is designated as $$25H6,$$ then the upper limit of the bore in $$mm$$ is