1
GATE PI 2009
MCQ (Single Correct Answer)
+2
-0.6
Match the following
2
GATE PI 2009
MCQ (Single Correct Answer)
+2
-0.6
An autocollimator is used to
3
GATE PI 2008
MCQ (Single Correct Answer)
+2
-0.6
An experimental setup is planned to determine the taper of work piece as shown in the figure. If the two precision rollers have radii $$8mm$$ and $$5mm$$ and the total thickness of slip gauges inserted between the rollers is $$15.54mm,$$ the taper angle $$'\theta '$$ is
4
GATE PI 2008
MCQ (Single Correct Answer)
+2
-0.6
The following data are given for calculating limits of dimensions and tolerances for a hole: Tolerance unit $$'i'$$ (microns) $$=0.45$$ $${\left( D \right)^{1/3}} + 0.001D.$$ The unit of $$D$$ is $$mm.$$ Diameter step is $$18-30.$$ If the fundamental deviation for hole $$H$$ is zero and $${\rm I}T8 = 26i$$ the maximum and minimum limits of dimension for a $$25{H_8}$$ hole (in $$mm$$) are
Questions Asked from Metrology and Inspection (Marks 2)
Number in Brackets after Paper Indicates No. of Questions
GATE PI 2015 (2)
GATE PI 2014 (1)
GATE PI 2013 (1)
GATE PI 2012 (1)
GATE PI 2011 (2)
GATE PI 2010 (1)
GATE PI 2009 (2)
GATE PI 2008 (2)
GATE PI 2007 (2)
GATE PI 2006 (2)
GATE PI 2005 (1)
GATE PI 2004 (1)
GATE PI 1995 (2)
GATE PI 1994 (1)
GATE PI 1993 (2)
GATE PI 1992 (2)
GATE PI 1991 (1)
GATE PI 1990 (1)
GATE PI 1989 (1)
GATE PI Subjects
Engineering Mechanics
Strength of Materials
Theory of Machines
Engineering Mathematics
Machine Design
Fluid Mechanics
Thermodynamics
Casting
Joining of Materials
Metal Forming
Machine Tools and Machining
Metrology
Industrial Engineering