1
GATE PI 1995
Fill in the Blanks
+2
-0
The least count of a $$200$$ $$mm$$ long spirit level is given as $$10$$ seconds per division. The gradient of the spirit level expressed as $$mm$$ over one meter is _____________.
2
GATE PI 1995
Fill in the Blanks
+2
-0
The diameter of a hole is given as $${50^{\matrix{ { + 0.15} \cr { + 0.00} \cr } }}\,\,mm.$$ The upper limit on the dimension in $$mm,$$ of the shaft for achieving maximum interference of $$50micron$$ is .................
3
GATE PI 1994
Fill in the Blanks
+2
-0
A hole is specified as $$\phi 30 \pm 0.04mm$$ with $$\phi \,\,0.01\,\,M.$$ The virtual diameter of the hole (i.e the maximum diameter of the pin that can enter the hole ) is ________________
4
GATE PI 1993
Subjective
+2
-0
Holes $$1,2,3,4$$ drilled in sequence , with angular positions and tolerances are shown in Figure. Evaluate closing angle $$'X'$$ with its tolerance band. GATE PI 1993 Metrology - Metrology and Inspection Question 22 English
EXAM MAP