1
GATE PI 2007
MCQ (Single Correct Answer)
+2
-0.6
Tolerance on the dimension $$'x'$$ in the two component assembly shown below is (all dimensions are in $$mm$$)
2
GATE PI 2007
MCQ (Single Correct Answer)
+2
-0.6
A tool with side cutting edge angle of $$30$$ degrees and end cutting edge angle $$10deg$$ is used for fine turning with a feed of $$1mm/rev$$. Neglecting nose radius of the tool, the maximum (peak to valley) height of the surface roughness produced will be
3
GATE PI 2006
MCQ (Single Correct Answer)
+2
-0.6
The surface finish of the component produced by a grinding process was measured. Based on roughness parameters obtained, which one of the following is true
4
GATE PI 2006
MCQ (Single Correct Answer)
+2
-0.6
A keyway of $$5$$ $$mm$$ depth is to be milled in a shaft of diameter $$60 \pm 0.1\,\,$$ by positioning the shaft in a $$V$$-block of angle $$120deg$$ and setting the tool with reference to the intersection of the face of the $$V$$-block. The error due to shaft tolerance which would be transferred on to the component is
Questions Asked from Metrology and Inspection (Marks 2)
Number in Brackets after Paper Indicates No. of Questions
GATE PI 2015 (2)
GATE PI 2014 (1)
GATE PI 2013 (1)
GATE PI 2012 (1)
GATE PI 2011 (2)
GATE PI 2010 (1)
GATE PI 2009 (2)
GATE PI 2008 (2)
GATE PI 2007 (2)
GATE PI 2006 (2)
GATE PI 2005 (1)
GATE PI 2004 (1)
GATE PI 1995 (2)
GATE PI 1994 (1)
GATE PI 1993 (2)
GATE PI 1992 (2)
GATE PI 1991 (1)
GATE PI 1990 (1)
GATE PI 1989 (1)
GATE PI Subjects
Engineering Mechanics
Strength of Materials
Theory of Machines
Engineering Mathematics
Machine Design
Fluid Mechanics
Thermodynamics
Casting
Joining of Materials
Metal Forming
Machine Tools and Machining
Metrology
Industrial Engineering