The alignment test ''Spindle square with base plate'' is applied to the radial drilling machine. A dial indicator is fixed to the cylindrical spindle and the spindle is rotated to make the indicator touch the base plate at different points. The test inspects whether the

Cylindrical pins of $${25^{\matrix{ { + 0.020} \cr { + 0.010} \cr } }}\,\,mm$$ diameter are electroplated in a shop. Thickness of the plating is $$30 \pm 0.2$$ micron. Neglecting gage tolerances, the size of the $$GO$$ gage in $$mm$$ to inspect the plated components is

A Sine bar has a length of $$250mm.$$ Each roller has a diameter of $$20mm.$$ During taper angle measurement of a component, the height from the surface plate to the center of a roller is $$100mm.$$ The calculated taper angle (in degrees) is

To measure the effective diameter of an external metric thread (included angle is $$60$$ degrees) of $$3.5$$ $$mm$$ pitch, a cylindrical standard of $$30.5$$ $$mm$$ diameter and two wires of $$2$$ $$mm$$ diameter each are used. The micrometer reading over the standard and over the wires are $$16.532$$ $$mm$$ and $$15.398$$ $$mm$$ respectively. The effective diameter (in $$mm$$) of the thread is