In an orthogonal cutting test, the following observations were made
Cutting force $$=1200N ;$$ Thrust force $$=500N$$
Tool rake angle $$=zero ;$$ Cutting speed $$=1$$ $$m/s,$$
Depth of cut $$=0.8mm;$$
Chip thickness $$=1.5$$ $$mm$$

Friction angle during machining will be

Circular blanks of $$35$$ $$mm$$ diameter are punched from a steel sheet of $$2$$ $$mm$$ thickness. If the clearance per side between the punch and die is to be kept as $$40$$ microns, the sizes of punch and die should respectively be.

The maximum possible percentage reduction in area per pass during wire drawing of an ideal plastic material without friction is of the order of

Tolerance on the dimension $$'x'$$ in the two component assembly shown below is (all dimensions are in $$mm$$)