An autocollimator is used to

Match the following

An experimental setup is planned to determine the taper of work piece as shown in the figure. If the two precision rollers have radii $$8mm$$ and $$5mm$$ and the total thickness of slip gauges inserted between the rollers is $$15.54mm,$$ the taper angle $$'\theta '$$ is

The following data are given for calculating limits of dimensions and tolerances for a hole: Tolerance unit $$'i'$$ (microns) $$=0.45$$ $${\left( D \right)^{1/3}} + 0.001D.$$ The unit of $$D$$ is $$mm.$$ Diameter step is $$18-30.$$ If the fundamental deviation for hole $$H$$ is zero and $${\rm I}T8 = 26i$$ the maximum and minimum limits of dimension for a $$25{H_8}$$ hole (in $$mm$$) are