$$A$$ $$30$$ $$mm$$ hole shaft assembly results in minimum and maximum clearances of $$0.03$$ $$mm$$ and $$0.30$$ $$mm$$ respectively. The hole has a unilateral tolerance with zero fundamental deviation. If the tolerance on the shaft is $$0.08$$ $$mm,$$ the maximum size of the hole is

The combination of slip gauges to obtain a dimension of $$10.35$$ $$mm$$ will be

Assertion (A): Basic hole system is advocated by Indian Standards for fit design
Explanation (E): Holes can be produced to any size.

Outside diameter of bush is turned using a mandrel. The mandrel diameter is maintained as $${30^{\matrix{ { + 0.000} \cr { - 0.050} \cr } }}\,\,mm$$ and the bore diameter is $${30^{\matrix{ { + 0.050} \cr { - 0.000} \cr } }}\,\,mm$$. The maximum value in $$mm$$ of the eccentricity on the bush due to the locating mandrel