In a single pass rolling process using $$410mm$$ diameter steel rollers, a strip of width $$140mm$$ and thickness $$8mm$$ undergoes $$10\% $$ reduction of thickness. The angle of bite in radians is

A solid cylinder of diameter $$100$$ $$mm$$ and height $$50$$ $$mm$$ is forged between two frictionless flat dies to a height of $$25$$ $$mm.$$ The percentage change in diameter is

A Sine bar has a length of $$250mm.$$ Each roller has a diameter of $$20mm.$$ During taper angle measurement of a component, the height from the surface plate to the center of a roller is $$100mm.$$ The calculated taper angle (in degrees) is

In an interchangeable assembly, shafts of size $${25.000^{\matrix{ { + 0.040} \cr { - 0.010} \cr } }}\,\,mm$$ mate with holes of size $${25.000^{\matrix{ { + 0.030} \cr { + 0.020} \cr } }}\,\,mm.$$

The maximum interference (in microns) in the assembly is