Match the following

A blank of $$50$$ $$mm$$ diameter is to be sheared from a sheet of $$2.5$$ $$mm$$ thickness. The required radial clearance between the die and the punch is $$6\% $$ of sheet thickness. The punch and die diameter $$(mm)$$ for this blanking operation respectively are

The following data are given for calculating limits of dimensions and tolerances for a hole: Tolerance unit $$'i'$$ (microns) $$=0.45$$ $${\left( D \right)^{1/3}} + 0.001D.$$ The unit of $$D$$ is $$mm.$$ Diameter step is $$18-30.$$ If the fundamental deviation for hole $$H$$ is zero and $${\rm I}T8 = 26i$$ the maximum and minimum limits of dimension for a $$25{H_8}$$ hole (in $$mm$$) are

An experimental setup is planned to determine the taper of work piece as shown in the figure. If the two precision rollers have radii $$8mm$$ and $$5mm$$ and the total thickness of slip gauges inserted between the rollers is $$15.54mm,$$ the taper angle $$'\theta '$$ is