The number of defective produced by a six sigma process (in Parts per million) is

The quick return mechanism used in shaper has rocker arm drive of length $$200mm.$$ If the crank radius is $$50mm$$ and the offset between crank center and rocker arm pivot is $$20mm,$$ length of the stroke (in meters) is

Blind hole $$10mm$$ diameter, $$50mm$$ deep are being drilled in steel block, drilling spindle speed is $$600rpm$$, feed $$0.2$$$$mm/rev,$$ point angle of drill is $$120.$$

During the above operation, the drill wears out after producing $$200$$ holes. Taylor's tool life equation is of the form $$V{T^{0.3}} = C,$$ where $$V=$$ cutting speed in $$m/min$$ and $$T=$$ tool life in $$min.$$ Taylor's constant $$C$$ will be

Blind hole $$10mm$$ diameter, $$50mm$$ deep are being drilled in steel block, drilling spindle speed is $$600rpm$$, feed $$0.2$$$$mm/rev,$$ point angle of drill is $$120.$$

Machining time (in min) per hole will be