1
GATE PI 2006
MCQ (Single Correct Answer)
+2
-0.6
In a surface broaching process, a broach having $$5mm$$ pitch and cut per teeth $$0.05mm$$ is used for reducing the thickness by $$6mm.$$ If the length of the work piece is $$50mm$$ and the cutting speed is $$0.05m/s,$$ the time required / pass in seconds is
A
$$11$$
B
$$12$$
C
$$13$$
D
$$1200$$
2
GATE PI 2006
MCQ (Single Correct Answer)
+2
-0.6
It is required to punch a hole of diameter $$10mm$$ on a sheet of thickness $$3mm.$$ The shear strength of the work material is $$420MPa.$$ The required punch force is
A
$$19.78$$ $$kN$$
B
$$39.56$$ $$kN$$
C
$$98.9$$ $$kN$$
D
$$395.6$$ $$kN$$
3
GATE PI 2005
MCQ (Single Correct Answer)
+2
-0.6
A $$\phi \,\,25$$ $$mm$$ hole is pierced in a $$t=2.5mm$$ thick steel sheet having shear strength $$\tau = 350\,\,MPa.$$ If the diametral clearance is given by the expression $$C=0.0064$$ $$t$$ $$\sqrt \tau ,$$ the die diameter (in $$mm$$), punch diameter (in $$mm$$) and punch force in $$(kN)$$ respectively are
A
$$25.0, 25.3, 171.8$$
B
$$25.0, 24.7, 68.75$$
C
$$24.7, 25.0, 171.8$$
D
$$25.3, 25.0, 68.75$$
4
GATE PI 2004
MCQ (Single Correct Answer)
+2
-0.6
A cylindrical cup of $$48.5$$ $$mm$$ diameter and $$52$$ $$mm$$ height has a corner radius of $$1.5$$ $$mm$$ Cold rolled steel sheet of thickness $$1.5$$ $$mm$$ is used to produce the cup. Assume trim allowance as $$2$$ $$mm$$ per $$25$$ $$mm$$ of cup diameter. What is the blank size in $$mm$$ ?
A
$$102.0$$
B
$$115.4$$
C
$$120.5$$
D
$$128.5$$
EXAM MAP
Medical
NEETAIIMS
Graduate Aptitude Test in Engineering
GATE CSEGATE ECEGATE EEGATE MEGATE CEGATE PIGATE IN
Civil Services
UPSC Civil Service
Defence
NDA
Staff Selection Commission
SSC CGL Tier I
CBSE
Class 12