1
GATE PI 2004
MCQ (Single Correct Answer)
+2
-0.6
A cylindrical cup of $$48.5$$ $$mm$$ diameter and $$52$$ $$mm$$ height has a corner radius of $$1.5$$ $$mm$$ Cold rolled steel sheet of thickness $$1.5$$ $$mm$$ is used to produce the cup. Assume trim allowance as $$2$$ $$mm$$ per $$25$$ $$mm$$ of cup diameter. What is the blank size in $$mm$$ ?
A
$$102.0$$
B
$$115.4$$
C
$$120.5$$
D
$$128.5$$
2
GATE PI 2004
MCQ (Single Correct Answer)
+2
-0.6
Determine the load required to punch a $$20$$ $$mm$$ diameter hole in $$2$$ $$mm$$ thick sheet. The properties of the material of the sheet are:
Tensile strength $$-580$$ $$MPa;$$
Yield strength in tension $$-410$$ $$MPa$$
Shear strength $$-350$$ $$MPa;$$
Yield strength in shear $$-250$$ $$MPa$$

The load in $$kN$$ is:

A
$$31.40$$
B
$$43.98$$
C
$$64.40$$
D
$$91.10$$
3
GATE PI 2004
MCQ (Single Correct Answer)
+2
-0.6
A hole of $$40$$ $$mm$$ diameter is pierced in a steel sheet of $$4$$ $$mm$$ thickness without shear on the tool. Shear strength of steel is $$400$$ $$N/m{m^2},$$ and penetration is $$25\% .$$ What is the expected percentage load reduction if a shear of $$1$$ $$mm$$ is provided on the punch?
A
$$25.00$$
B
$$33.33$$
C
$$50.00$$
D
$$66.67$$
4
GATE PI 2004
MCQ (Single Correct Answer)
+2
-0.6
In deep drawing of sheet metal, spring loaded stripper clamps the work until:
A
The punch penetrates twice the stock thickness
B
It removes wrinkles on the product edges
C
Shedder removes the work from the tools
D
Punch is completely withdrawn from the work material
EXAM MAP
Medical
NEETAIIMS
Graduate Aptitude Test in Engineering
GATE CSEGATE ECEGATE EEGATE MEGATE CEGATE PIGATE IN
Civil Services
UPSC Civil Service
Defence
NDA
Staff Selection Commission
SSC CGL Tier I
CBSE
Class 12