1
GATE PI 2008
MCQ (Single Correct Answer)
+2
-0.6
A blank of $$50$$ $$mm$$ diameter is to be sheared from a sheet of $$2.5$$ $$mm$$ thickness. The required radial clearance between the die and the punch is $$6\% $$ of sheet thickness. The punch and die diameter $$(mm)$$ for this blanking operation respectively are
A
$$50.00$$ & $$50.30$$
B
$$50.00$$ & $$50.15$$
C
$$49.70$$ & $$50.00$$
D
$$49.85$$ & $$50.00$$
2
GATE PI 2007
MCQ (Single Correct Answer)
+2
-0.6
Circular blanks of $$35$$ $$mm$$ diameter are punched from a steel sheet of $$2$$ $$mm$$ thickness. If the clearance per side between the punch and die is to be kept as $$40$$ microns, the sizes of punch and die should respectively be.
A
$$35$$ & $$35.040$$
B
$$34.92$$ & $$35$$
C
$$35$$ & $$35.080$$
D
$$35.040$$ & $$34.92$$
3
GATE PI 2006
MCQ (Single Correct Answer)
+2
-0.6
A cup is to be drawn to a diameter of $$70mm$$ with $$35mm$$ depth from a $$0.5mm$$ thick sheet metal. The cup is drawn in one operation. Assume $${\sigma _u} = 430\,\,MPa.$$

The required blank diameter is

A
$$86.7mm$$
B
$$119.5mm$$
C
$$121.24mm$$
D
$$169mm$$
4
GATE PI 2006
MCQ (Single Correct Answer)
+2
-0.6
A cup is to be drawn to a diameter of $$70mm$$ with $$35mm$$ depth from a $$0.5mm$$ thick sheet metal. The cup is drawn in one operation. Assume $${\sigma _u} = 430\,\,MPa.$$

The maximum drawing force is

A
$$0.047MN$$
B
$$0.82MN$$
C
$$0.83MN$$
D
$$9.69MN$$
EXAM MAP
Medical
NEETAIIMS
Graduate Aptitude Test in Engineering
GATE CSEGATE ECEGATE EEGATE MEGATE CEGATE PIGATE IN
Civil Services
UPSC Civil Service
Defence
NDA
Staff Selection Commission
SSC CGL Tier I
CBSE
Class 12