Reamer is designed to have even number of flutes to:

The following data apply to machining a part on turret lathe and a general purpose lathe

The setup cost and the cost for special tooling on the turret lathe would be $$Rs.3000/-.$$ These costs are negligible on the general purpose lathe. Calculate the batch seize which justifies the use of turret lathe.

A parting tool has a ground front clearance angle of $${6^0}$$ and the back rake angle of $${10^0}$$. The tool, by mistake, was set $$1.5$$ $$mm$$ above the line of centers while machining a job of $$50$$ $$mm$$ out-side diameter.

The diameter of the job at which, while parting, the tool will start rubbing

A parting tool has a ground front clearance angle of $${6^0}$$ and the back rake angle of $${10^0}$$. The tool, by mistake, was set $$1.5$$ $$mm$$ above the line of centers while machining a job of $$50$$ $$mm$$ out-side diameter.

The effective rake and clearance angle are