1
GATE PI 1989
MCQ (Single Correct Answer)
+1
-0.3
If the $$z$$-axis & $$x$$-axis of $$CNC$$ lathe are provided with straight line controls, it is possible to carry out
A
Turning and facing only
B
Turning facing and taper turning
C
Turning, facing and thread cutting
D
Turning, facing and drilling
2
GATE PI 1989
MCQ (Single Correct Answer)
+1
-0.3
Collapsible tubes are made by
A
Drawing
B
spinning
C
Extrusion
D
Rolling
3
GATE PI 1989
MCQ (Single Correct Answer)
+1
-0.3
The blank diameter used in thread rolling will be
A
Equal to the major diameter of the thread
B
Equal to the pitch diameter of the thread
C
little higher than the minor diameter of the thread
D
little higher than the pitch diameter of the thread
4
GATE PI 1989
Fill in the Blanks
+1
-0
At the last hammer stroke the excess material from the finishing cavity of a forging die is pushed into .............
EXAM MAP
Medical
NEET
Graduate Aptitude Test in Engineering
GATE CSEGATE ECEGATE EEGATE MEGATE CEGATE PIGATE IN
CBSE
Class 12