The total angular movement (in degrees) of a lead screw with a pitch of $$5.0mm$$ to drive the work table by a distance of $$200mm$$ in a $$NC$$ machine is

A titanium sheet of $$5.0mm$$ thickness is cut by wire cut $$EDM$$ process using a wire of $$1.0mm$$ diameter. A uniform spark gap of $$0.5mm$$ on both sides of the wire is maintained during cutting operation. If the feed rate of the wire into the sheet is $$20mm/min,$$ the material removal rate (in $$m{m^3}/\min $$) will be

Suppose point $$P1$$ in $$APT$$ (Automatically programmed Tool) programming is coded by statement
$$P1 = POINT/XSMALL,\,\,\,INTOF,\,\,\,LN1,\,\,CR1$$

The coded geometric situation without causing error is

A stepper motor has $$150$$ steps. The output shaft of the motor is directly coupled to a lead screw of pitch $$4mm,$$ which drives a table. If the frequency of pulse supply to the motor is $$200Hz$$, the speed of the table (in $$mm/min)$$ is