The diameter and rotational speed of a job are $$100mm$$ and $$500$$ $$rpm$$ respectively. The high spots (chatter marks) are found at a spacing of $$30$$ $$deg$$ on the job surface. The chatter frequency is

A milling cutter having $$8$$ teeth is rotating at $$100$$ $$rpm.$$ The work piece feed is set at $$40mm/min$$. The feed per tooth is

If the number of double strokes per minute in a shaper is calculated by ($$0.643\, \times \,$$ Cutting speed in $$mm/min$$) / length of the stroke in $$m,$$ then the return speed is faster than the cutting speed by

Match the following