A machined surface with standard symbols indicating the surface texture is shown in the Figure. (ALL dimensions in the Figure are in micrometer).

The waviness height (in micrometer) of the surface is

The limits of a shaft designated as $$100h5$$ are $$100.000$$ $$mm$$ and $$100.014$$ $$mm.$$ Similarly, the limits of a shaft designated as $$100h8$$ are $$100.000$$ $$mm$$ and $$100.055$$ $$mm.$$ If a shaft is designated as $$100h6,$$ the fundamental deviation (in $$\mu m$$ ) for the same is

The roughness profile of a surface is depicted below.

The surface roughness parameter $${R_a}\,\,$$ (in $$\mu m$$) is ________________.

In an interchangeable assembly, shafts of size $${25.000^{\matrix{ { + 0.040} \cr { - 0.010} \cr } }}\,\,mm$$ mate with holes of size $${25.000^{\matrix{ { + 0.030} \cr { + 0.020} \cr } }}\,\,mm.$$

The maximum interference (in microns) in the assembly is