The limits of a shaft designated as $$100h5$$ are $$100.000$$ $$mm$$ and $$100.014$$ $$mm.$$ Similarly, the limits of a shaft designated as $$100h8$$ are $$100.000$$ $$mm$$ and $$100.055$$ $$mm.$$ If a shaft is designated as $$100h6,$$ the fundamental deviation (in $$\mu m$$ ) for the same is

The roughness profile of a surface is depicted below.

The surface roughness parameter $${R_a}\,\,$$ (in $$\mu m$$) is ________________.

In an interchangeable assembly, shafts of size $${25.000^{\matrix{ { + 0.040} \cr { - 0.010} \cr } }}\,\,mm$$ mate with holes of size $${25.000^{\matrix{ { + 0.030} \cr { + 0.020} \cr } }}\,\,mm.$$

The maximum interference (in microns) in the assembly is

The geometric tolerance that does not need a datum for its specification is