1
GATE PI 1992
Subjective
+5
-0
Two sheets of low carbon steel $$1.5mm$$ thick each are spot welded by passing a current $$10000$$ amps for $$5$$ cycles in $$50$$ $$Hz$$ main supply.

i) What is the heat generated due to the supply of power if effective resistance has $$200$$ micro ohms,

ii) The maximum indentation is $$10\% $$ of sheet thickness and density of the spot weld nugget $$8$$ $$gm/cc.$$ If $$1380$$ Joules are required to melt $$1gm$$ of steel, determine heat required for welding operation if $$D=6SQRT$$ $$(t)$$ to determine nugget diameter $$D$$ and assume the nugget size to be equal to metal between the two electrodes

2
GATE PI 1991
MCQ (Single Correct Answer)
+5
-1.5
The voltage-arc length characteristic of a $$DC$$ arc is given by $$V=20+40L.$$ where $$L=$$ arc length in $$cm.$$ The power source characteristics can be approximated by a straight line. Open circuit is $$80V$$ and short circuit current $$1000$$Amps. The optimum arc length in $$mm$$
A
$$0.5$$
B
$$1$$
C
$$5$$
D
$$10$$
3
GATE PI 1991
Subjective
+5
-0
A resistance welder is rated at $$50$$ $$kVA,$$ at $$50\% $$ duty cycle. Secondary voltage is always constant at $$25$$ volts. If a job requires $$1500$$Amps current, determine the maximum welding time in a total cycle time of $$30$$$$secs$$.
EXAM MAP
Medical
NEETAIIMS
Graduate Aptitude Test in Engineering
GATE CSEGATE ECEGATE EEGATE MEGATE CEGATE PIGATE IN
Civil Services
UPSC Civil Service
Defence
NDA
Staff Selection Commission
SSC CGL Tier I
CBSE
Class 12