GATE PI 1993
View Questions

GATE PI

A casting of $$200\,\,mm\,\, \times \,\,100\,\,mm \times 70\,\,mm$$ size solidifies in ten minutes. Estimate solidificat
View Question
Manufacturing process $$\,\,\,\,\,\,\,\,\,\,\,\,$$ Property
View Question
During gas welding of copper sheets a neutral flame was used consuming $$8$$ liters of acetylene. But the weld was found
View Question
The voltage-arc length characteristics of a power source is $$V=20+40L,$$ where $$V=$$ operating voltage in volts and $$
View Question
In a cutting test with $$0.3mm$$ flank wear as tool failure criterion, a tool life of $$10min$$ was obtained at a cuttin
View Question
A work-piece of $$2000$$ $$mm$$ length and $$300$$ $$mm$$ width was machined by a planning operation with the feed set
View Question
Match the following
View Question
Match the following
View Question
Calculate the minimum number of hot rolling passes necessary to reduce an ingot of $$200mm$$ thickness to $$100mm$$ thic
View Question
The maximum interference in $$mm$$ after assembly between a bush of size $${30^{\matrix{ { + 0.06} \cr { + 0.03}
View Question
Holes $$1,2,3,4$$ drilled in sequence , with angular positions and tolerances are shown in Figure. Evaluate closing ang
View Question
EXAM MAP
Medical
NEETAIIMS
Graduate Aptitude Test in Engineering
GATE CSEGATE ECEGATE EEGATE MEGATE CEGATE PIGATE IN
Civil Services
UPSC Civil Service
Defence
NDA
Staff Selection Commission
SSC CGL Tier I
CBSE
Class 12