1
GATE PI 2015
MCQ (Single Correct Answer)
+1
-0.3
During turning of mild steel work material, the maximum temperature is observed at
A
Primary deformation zone
B
Tool and chip interface
C
Tool-flank and work interface
D
Machined sub-surface
2
GATE PI 2015
MCQ (Single Correct Answer)
+1
-0.3
Built-up edge formation decreases under the conditions listed below EXCEPT
A
at low cutting speeds
B
using large positive rake angle
C
with shaper tool
D
using cutting fluid
3
GATE PI 2014
MCQ (Single Correct Answer)
+1
-0.3
A spindle speed of $$300$$ $$rpm$$ and a feed $$0.3mm/revolution$$ are chosen for longitudinal turning operation on an engine lathe. In finishing pass, roughness on the work surface can be reduced by
A
reducing the spindle speed
B
increasing the spindle speed
C
reducing the feed of tool
D
increasing the feed of tool
4
GATE PI 2009
MCQ (Single Correct Answer)
+1
-0.3
Diamond cutting tools are not recommended for machining of ferrous metals due to
A
High tool hardness
B
High thermal conductivity of the work material
C
Poor tool roughness
D
Chemical affinity of tool material with iron
EXAM MAP
Joint Entrance Examination
JEE MainJEE AdvancedWB JEEBITSAT
Medical
NEET
Graduate Aptitude Test in Engineering
GATE CSEGATE ECEGATE EEGATE MEGATE CEGATE PIGATE IN