1
GATE PI 2015
MCQ (Single Correct Answer)
+1
-0.3
Built-up edge formation decreases under the conditions listed below EXCEPT
A
at low cutting speeds
B
using large positive rake angle
C
with shaper tool
D
using cutting fluid
2
GATE PI 2014
MCQ (Single Correct Answer)
+1
-0.3
A spindle speed of $$300$$ $$rpm$$ and a feed $$0.3mm/revolution$$ are chosen for longitudinal turning operation on an engine lathe. In finishing pass, roughness on the work surface can be reduced by
A
reducing the spindle speed
B
increasing the spindle speed
C
reducing the feed of tool
D
increasing the feed of tool
3
GATE PI 2009
MCQ (Single Correct Answer)
+1
-0.3
Diamond cutting tools are not recommended for machining of ferrous metals due to
A
High tool hardness
B
High thermal conductivity of the work material
C
Poor tool roughness
D
Chemical affinity of tool material with iron
4
GATE PI 2008
MCQ (Single Correct Answer)
+1
-0.3
Diamond cutting tools are not recommended for machining of ferrous metals to
A
High tool hardness
B
High thermal conductivity of work material
C
Poor tool toughness
D
Chemical affinity of tool material with iron
EXAM MAP
Medical
NEET
Graduate Aptitude Test in Engineering
GATE CSEGATE ECEGATE EEGATE MEGATE CEGATE PIGATE IN
CBSE
Class 12