ExamSIDE.Com

© ExamSIDE.Com 2019

About Us Privacy Policy

GATE Mechanical 1987 Question

Subjective Type Answer by Yourself
During orthogonal turning of a steel rod by zero rake tool at feed $$0.25mm/rev$$ and depth of cut $$2.0mm,$$ the following observations were obtained. Tangential component of cutting force $$=1000N$$, Axial component of cutting force $$=500N,$$ chip thickness $$=1.0mm,$$ with the help of diagram determine the yield shear strength of work material under the given cutting conditions.

GATE Mechanical 1987 Question

Subjective Type Answer by Yourself
In a turning operation the tool life of the carbide tool was found to be $$20min$$ and $$100min,$$ at cutting speeds of $$120m/min$$ and $$80m/min$$ respectively. What will be the tool life of the tool under same condition but at a cutting speed of $$100m/min.$$

GATE Mechanical 1989 Question

Subjective Type Answer by Yourself
In an orthogonal cutting test on the following data were obtained
Uncut chip thickness $$=0.25mm,$$ Cutting speed: $$60m/min,$$ Tool rake angle: $$0$$ Chip thickness $$0.75mm,$$ Cutting force : $$900$$ $$N$$, Thrust force : $$450$$ $$N$$

Calculate the shear angle, total power in making the cut and coefficient of friction between the chip tool interface.

GATE Mechanical 1989 Question

Subjective Type Answer by Yourself
The following data is available for machining a component on a turret or center lathe: find out the total number of components to be machined to justify the use of turret lathe

Share